Marvel MP24FAS4LS Příručka a uživatelská příručka stáhnout pdf (Strana 8)

Power Failure

Starting your appli-

ance:

Plug the appliance power

cord into a 115 volt wall outlet. Your ap-

pliance is shipped from the factory in the "On" po-

sition and will begin start-up of cooling as soon as

power is supplied. If the appliance does not start,

conrm that the wall outlet has power, and that the

control is in the "On" position, (See "Turning your

appliance On and Off" below).

The control display is covered with a clear plastic

lm. This lm may be removed by carefully lifting

the lm at a corner.

On initial power up, the control display will indicate

a "Power Failure" alarm. This is a normal condition

as the appliance was powered-up at the factory for

quality inspection and then removed from power. A

momentary press of the "On/Off" keypad will reset

this alarm condition. (See Alarms section on page

10).

ALARM RESET

NOTE

Your product has an automatic defrost feature that

utilizes an electric heater element. Periodically

during defrost you may observe the following:

• Water dripping and running sounds as a

result of the frost melt

• Sizzling and popping sounds from water

dripping on the heater element

• A faint reddish glow in the freezer compart-

ment from the electric heater element

These are all “normal” operating characteristics

related to refrigeration product incorporating auto-

matic defrost. They do not represent any product

fault or safety issue.

Temp

Minus

keypad

Temp

Plus

keypad

On/Off

keypad

Light

keypad

Display Area

Lock

keypad

System Status

indicators

Figure 10

Electronic single zone control

Sleep mode:

If no keypads are pressed for 60 seconds, the

display will enter sleep mode to conserve power.

The control panel will go dark with the exception of

the system status "OK" indicator which will remain

enabled. Alarm conditions will wake the display,

(see alarms on page 10).

To make the following changes to the con-

trol settings (turning the appliance ON/OFF,

adjusting the temperature, changing the interior

lights, and activating vacation mode), the con-

trol must be awake.

To wake the display press any keypad. A conrm

tone will sound, and the current storage compart-

ment temperature will be displayed.

Using your electronic control:

The sleep mode can be disabled if you prefer to

have the display on continuously. Press and hold

the "Lock" keypad until the display goes past "Loc"

and reads "nSL". To enable the sleep mode, repeat

the instruction, again going past "Loc" until the

display reads "SLP".

Turning your appliance ON and OFF:

If the appliance is "On", (and out of sleep mode) the

temperature will be shown in the display area of the

control. To turn the appliance "Off", press and hold

the "On/Off" keypad for 4-seconds. "OFF" will now

be displayed on the control.

To turn the appliance "On", press and hold the "On/

Off" keypad for 4-seconds.

STARTING YOUR APPLIANCE

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 71 72

Komentáře k této Příručce

Žádné komentáře

Marvel MP24FAS4LS Příručka a uživatelská příručka Strana 8

Komentáře k této Příručce

Související produkty a manuály pro Nápojové chladiče Marvel MP24FAS4LS