Marvel 60CIM-SS-F Průvodce řešením problémů stáhnout pdf (Strana 7)

30iM Installation

Turn the ice machine to gain access to the rear of the 1.

unit. Remove the access panel by removing the ten

(10) screws (see Figure 6).

Plug the ice machine’s power plug into the outlet on 2.

the drain pump. Place the drain pump in the left, rear

opening of the ice machine with the inlet, vent, and

discharge ﬁttings to the rear of the unit (see Figure 7).

Install 1-3/4 in. x 5/8 in. I.D. inlet tubing to drain 3.

barb on ice machine and then on the inlet of the drain

pump. Clamp both ends of the tube with the large

tubing clamps.

Connect the 18 in. x 3/8 in. I.D. formed vent tube to 4.

the vent on the drain pump and secure with one (1) of

the small tubing clamps.

Route a short section of the 20 ft. x 3/8 in. I.D. tube 5.

through the opening in the access panel and connect

it to the discharge of the drain pump. Secure with the

small tubing clamp.

Route the vent tube and the drain pump power cord 6.

through the remaining openings in the access panel as

shown in Figure 8. Reinstall the panel and secure.

Secure the vent tube to the back of the ice machine 7.

using the supplied tubing clips and screws as shown in

Figure 8.

The vent tube must be attached and secured or water

damage may occur. Make certain there are no kinks in

the tube. The drain pump will not operate correctly with

a partially blocked vent line.

Connect the discharge tube to a suitable drain. Cut 8.

excess tubing as needed. Do NOT allow sags or kinks

in the tubing that will restrict ﬂow.

Make certain that the drain pump is level in the ice 9.

machine’s rear opening.

Plug the power cord of the drain pump into a properly 10.

grounded 115VAC receptacle.

Test the drain pump by slowly pouring water into the 11.

ice machine ice storage bin. Approximately one (1)

quart of water is required to activate the drain pump.

Test the operation of the safety switch by turning the ice 12.

machine on and completely restricting the discharge

line while the pump is operating. Pour more water into

the ice machine’s ice storage bin until the ice machine

turns off. The drain pump will continue to operate.

Remove the discharge tube restriction and allow the

water to be pumped out. The power to the ice ma-

chine will be restored when the water in the pump

returns to normal.

Place the ice machine in the installed location. En-13.

sure that all tubing and power cords are not pinched,

kinked, or disturbed.

Figure 6

Figure 7

Receptacle for

Ice Machine’s Plug

Towards the Rear

of the Ice Machine

To Wall Receptacle

Inlet Tube

Fitting

Discharge

Tube Fitting

Vent Tube

Fitting

Access Panel

Figure 8

Vent Tube

Access Panel

To Drain

OPTIONAL DRAIN PUMP INSTALLATION

NOTE

Screws

Tubing Clips

Drain Pump’s

Power Cord

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Marvel 60CIM-SS-F Průvodce řešením problémů Strana 7

Komentáře k této Příručce

Související produkty a manuály pro ne Marvel 60CIM-SS-F